Still not convinced that our post pounder is the best on the market? See what a few of the many highly satisfied Man Saver Post Driver™ customers have to say about our revolutionary fence post driver. After you buy your post pounder, come back and share your story with us!
December 1, 2014
We purchased you man saver for our annual Holiday Nights and Lights. It's a 1 mile route where we display over 75 lighted displays. All these displays are held up with t-post. In the prior years we did all these displays (some displays had over 8-10 post) manually. We used the man saver this year and the it did what it's name implies ... it saved our butt. We couldn't of been happier. The only drawback was in extreme cold weather it tended to freeze the oil. Not sure if thinner oil might work better. However, for the most part it worked like a charm.Tim Kurtz
Ottumwa Area Chamber of Commerce
October 8, 2014
I've had it for a couple weeks, took it out the other day after I got my Polaris Ranger set up for the job. Up to 80-90 post in about a mile and a half in two days! I was shocked how a driver that weighs only 26lbs could drive posts in that hard of ground! Some loose rock and hardpan! Amazing! It hardly uses any air also, I run my compressor at an idle just fine.
Thanks Roher!Paul Coon
September 12, 2014
My property is 100% decomposed granite in Az. With the Man Saver I drove 100 3/8″ schedule 10 post 3′ deep in a day by myself at about 3 min per post. To give you an idea of how hard the ground is here it takes about 10 min to drive a T-post 1′ with a manual driver and 25 min to drill a 3′ X 9″ hole with the auger on my tractor. This tool is the best tool I own and recommend anyone that does work involving post’s own one. Made in the USA, how can you go wrong!Eric Wagner
September 10, 2014
Great product. Ground was very hard in the heat of the Summer but still worked well in driving posts 2+ feet. I can’t see ever going back to manually driving posts. It is just the right size and weight for a very mature fellow like myself, ha. The welds and finish on my driver were superb, nothing like built with American Pride. Thanks for the effort to keep standards high and innovative. Vr LaneyLaney Pankey
June 25, 2013
I bought 1 of these from you a week ago. Finally got to try it out over the weekend in hard & rocky dirt. We're in the Missouri Ozarks and we know hard dirt and rocks.
I'm real impressed with it. It performs as advertised and as shown in the videos. Outstanding.
Only thing I've found a problem is the handle used to tighten down on the t-posts does work loose in hard ground and it's pounding hard. I'm not a weakling by any means and I couldn't get it to keep from working loose. Wasn't a huge problem but it was real hot and I was getting irritable.
I'm starting to think you should put me on commission as you will probably be getting orders from other farmers and ranchers in the area. I'm putting in lots of posts along 3 busy roads. I had 3 people stop, watch and ask questions yesterday. I did your little demo of getting the post in a little ways and then let go of the handle and watch it pound itself the rest of the way.
May 2, 2013
Dear Mr. Rohrer
I received the package containing the O-Ring Kit, Allen Bolt, Handle, and T-post Clamp today. Ms. Maudie told me you were having them sent to me, but I was very surprised to get the other two items as well. It was totally unexpected. I would like to thank you very much for your kindness and consideration in this gesture.
Over the course of the past several weeks I’ve called your organization numerous times for assistance and advice trying to get the used Parker Post Driver I purchased from a local farm implement dealer back in operating condition. I’ve talked o Ms. Maudie, Ms. Tanya, and you. Each time I spoke to one of you I received very thorough and courteous help trying to resolve my issues. It is refreshing to know that there are still folks in this country who are conscientious enough about their product that they are willing to help a person in my situation. You and your organization certainly have my respect and appreciation.
C. Richard Conrad
I took delivery of your post pounder on Thursday. Over the weekend we set about 45 t posts for our 50 X 100 duck herding trial arena. For some people this would be a small project, but for my wife at 65 and myself at 66 years old it was a major project. We found the pounder to be as advertised. We were able to complete a project we never would have been able to do by hand. We know feel we can tackle a bigger project in the spring for a small sheep pasture. This was a great investment and worth every penny. --Robert G. Tripp CMA
Dear life, limb and time savers, My 98E Post Driver arrived immediately after ordering it, Thursday, and by Friday morning I had it pounding in my posts. I still find it hard to believe that I was finished with phase 1 of my fencing runs by that first Friday evening. I am a severe skeptic about buying anything online and worried that your online video of the 98E in action could possibly be like the rototiller commercials showing their product working in soft, pre-tilled dirt. Boy was I in for a pleasant surprise! First off, the 98E ran perfectly right out of the box on the ample air provided by my tiny, China made (cheap) electric air compressor plugged into my portable generator that was all sitting handy in my tractor bucket. By the time my ranch hand worked himself to the first corner, he said "This thing already paid for itself!" By the time he got going down the last long run, but only early in the same afternoon, he jokingly said "I think you bought this thing so you don't have to pay me!" ha* The truth is, the 98E has indeed already paid for itself in one day with only 1/2 of my fencing finished. The time (and effort) it has already saved my hired hand doing the job over what would have taken at least several days of back breaking labor if he had had to use a conventional T-post pounder makes me smile even as I type this. The 98E explained in one word? Incredible! This was not only money well spent on a solid, well built product, but a real investment in this current fencing project and every future fencing job I'll ever have to do. Thank you very much for such an awesome and easy to use product! -- Signed, A VERY SATISFIED CUSTOMER -- Steve Walls, Central Point, OR
I just wanted you to know that so far I am very pleased with my new 98E Post Driver. Two of us installed 90 t posts in very short order, and I was impressed with how well it worked once we got the hang of it. Thanks for the quick delivery and for making a good product. --Richard Mann, Roxbor, NC
It is a relief to do business with a company that is responsive to problems when they arise. Let me interject I find your post driver invaluable. So far I’ve been used it for the obvious- putting in fence posts through clay soil that resembles concrete, but I’ve been able to use it to drive support posts for a floating dock and am now driving pipe for a shallow well. Great product! --Michael Bailey, Berkeley, CA
My wife and I recently retired and are in the process of moving to Nevada. We are fencing 80 acres and decided to try your product. Thank you, without it we would have had to hire someone to set the T posts. Product works as advertised, works in rocky soil, and is easy enough for a retired attorney to master T post pounding. Thanks again, --Bill Fattarsi
I recently bought the 98E T Post Driver. I had to travel to another state to help my father put in fencing on two sides of his 10 acres. Each side was 660 feet, and I only had 6 days to clear all the old brush, trees and get the entire fence up in 6 days. It would have been impossible without this tool, It was a complete life saver. After talking to my father when we had originally thought about doing it all manually, there would have been no way to complete the job with the time frame I had to help him, not to mention saving our backs, shoulders and arms. Even though I think hands down this is an awesome tool there is room for a little improvement. If there would also be a handle on the post tighter screw it would help stabilize the post driver when you hit hard objects such as small rocks or tree roots and the post driver wants to move slightly. Also the Handle that is already supplied could be just a little longer, most people that operate them are men and have bigger hands and if it were approximately 2 inches longer it would make it easier to hold on to. I would definitely suggest this tool to anyone. -- Arlin Robb
"We have been using our post driver for 3 years and driven approximately 3500 posts. Aside from normal maintenance we have had very few problems. It allows us to drive posts in our rocky Ozarks soil. Repair parts are sent out quickly. Thanks for a great product." -- Doug Bowerman, Bowerman Farms
I just wanted to let you know that I tried out my new post driver last weekend. Including a couple little glitches it totally out performed my expectations. We drove 264 6' tee posts 2' in the ground in 8 hours. The soil had a little moisture in it which helped tremendously because it is usually hard pan all the way. None the less this is my huge thank you! Thank you for making a driver that I could afford to buy and then actually does the job too! --Terry Wiese, Hurricane, UT
"I am very impressed with my Man Saver T-Post Driver. I would never have completed the fencing job on my premises without the use of this handy tool. I installed six hundred feet of electric fence material with the use of your excellent tool in what appears to me to be cement type hardpan. After I purchased my post driver from you, I started to have reservations on whether your product would work in this kind of soil. I was very surprised! It worked great! This tool took quite a beating and so did I, but the job got done. Thank you for manufacturing a useful, quality product." -- Cliff Alexander, Tahuyah, Washington
"Whole company gives THUMBS UP! on the Man Saver T Post Driver." -- Roy Reed, Spring Valley Development, Colorado
"This is just a note to let you know the post driver I bought works great. The soil is very dry and hard, but the driver puts the posts down. It's a good product." -- Jasper Edwards, Condon, Oregon
I just wanted to drop you a line, to tell you how happy I am, with your product. I purchased your 99E-X driver about a month ago to drive in a new well point. My current water point had gone bad. It had been put in over 30 years ago and the pipes had rusted and created leaks. Absolutely no plumber in the state would drive in a new point, or work on one period. They all told me to put in a well. No one uses a point anymore. I called around and I received 3 estimates to put in a well. Several of my neighbors had used these companies and the average well depth seemed to be 660 feet, at a cost of more than $10,000. After buying your product, the new pipe, well point and fittings at a total cost of less than $1,000. I put in my new point at which is working wonderfully. It took me 2 ½ hours to driver over 25 feet of galvanized pipe in the ground. All while working in a space where I could barely stand, my basement. Thanks again for the great product and the great customer service that I received on the phone. -- Tom Hewitt, North Randolph, VT
I bought my post driver about 2 years ago but didn’t get to use it until recently. I drove about 40 t-posts in about an hour while building an entryway gate I needed to drive in a 2 3/8” kicker in some tough soil. I put 5ft of pipe in the ground in approx. 30 minutes. I’m so glad I bought it because my new place that I just bought needs all new fencing. It’s going to make my life much easier. -- John Rockafellow, Zephyr, TX
I bought your post driver about 3 years ago. I must have driven 10,000 or more posts. I bought a second one later. I am pleased with your product. I contract barbed wire fence by the mile and your products are a key part of my tool inventory. Keep up the good engineering. --Jimmy Stevens, Mantee, MS
"We are very impressed with the two 99E-W post drivers. All the guys love how light they are and how well they do the job. They told me these will not work. They are too small. Boy, were they wrong. All the guys at Universal Studios Hollywood give you a big high five." --Bud Steele, Universal Studios Hollywood, CA
Hello from Texas…just surfing the web and thought I would check out your site. I must say it’s as good as your product. I have a 98E Post Hole Driver. Hadn’t had much time to use on my 30 acres but when I do she pounds like a charm. I must say thank you for a good product it makes my neighbor jealous. --Joe Sirchia, Cleburne, TX
We recently bought our first small ranch. We have many fence lines to repair, and new fences to run. We spent a few weeks in the summer driving t-posts by hand, 2 of us swapping out every few minutes. It was incredibly hard work. I knew there must be an easier way. I found a pneumatic t-post driver at my local tractor supply store, however it was just not very successful, and we returned it the same week. I searched online and came across your product. After watching the online video I decided we would give it a try. Let me tell you a little about our property, we have several areas of very hard ground, it is not uncommon to wear out a set of bits on our post hole digger on just one hole (this is hard dirt, and not rock). I was skeptical your product would be able to drive posts into this ground; your website claimed your product “drives wherever a 35 lb. hand driver will work”, and we had driven posts using such driver (it could take 3 or 4 minutes a post, or longer when physical exhaustion set in). We recently took the new driver out to set a new fence line, I loaded the driver, a 10 gallon compressor and a gas powered generator into the bed of my pickup and set off to the top pasture with my laborer. We took the old manual “human powered” driver too, fully expecting to have to use it at times. Your product could only drive t-posts as deep on each stroke as we had been doing preciously by hand, it did however drive them much more quickly between strokes, and did not require rest breaks. I am not exaggerating when I tell you we set our fence line in half a day, when this would normally have taken 2 to 3 days! The first time we used it we made fools of ourselves, as the unit effortlessly drove the posts into the ground my laborer and I jumped up and down like giddy school children. Having used other pneumatic drivers without success, I strongly recommend this product. Thank you for saving me from tired muscles and an aching back! --David Andrews, Azle, TX
Last Monday I ordered for the next day delivery to Plainview, Texas, your Man-Saver T-Post Driver. On Wednesday and Thursday three of us built ½ mile of 5-wire fence using about 200 T-posts and driving these with our new driver. --Herb Stephens, Plainview, TX